to connect the hubs to the mainboard, i used some small flat usb c cables and stripped them of their rubber coating to expose their fpc cables, did some folds to clean up the slack, and connected them.to connect the top case and the webcam to the mainboard, i ended up getting this small usb module on the right that i soldered the connections to, which then feeds into this input shim that breaks out the connector into solderable points.the power button for the top case is a similar story, where i carefully removed the original membrane button and replaced it with a small button that breaks out into to header pins. those pins then plug into two wires that run to the same input shim to turn the mainboard on.
while val != 1 {
,这一点在新收录的资料中也有详细论述
На Западе подчинили рой насекомых для разведки в интересах НАТО08:43
Changes for Package Maintainers